The wife bought me a canoe motor for christmas (baby = no boat).
It's an old 2.5 hp Cruise N Carry. I took it out on our camping trip this last weekend. I don't know much about engines but I used the right mixture of oil / gas. The good news is I was also able to start the motor which means the engine works.
However, it would only run at full throttle. As soon as I would let up on the throttle at all it would cut out. I let it run for several minutes thinking it needed to warm up but no luck.
I wasn't able to put it into gear as the directions said not to pull the clutch unless the motor was in idle.
Any ideas?

